What exactly is the difference between a surge protector and a fuse? Can a fuse protect the electronic devices from lightning instead of surge protector?
Last Updated: 03.07.2025 05:00
There is no harm in having the surge suppressor along with the fuse in the circuit. The fuse will not open up until the current melts the link. This will take time, and in the interim, that jolt will get transmitted into the power supplies.
But it can get overloaded, and no longer works.
First Sentence:
Google, Meta and Snap think this tech is the next big thing - CNN
There are two important concepts here.
Edit 2024–10.
He then asserts :
Cyberpunk 2077 ‘incredible’ new release has fans floored - GAMINGbible
Upvotes:
At least they know the answer if they wanted it.
The third is lightning and “how it gets conducted into a home.”
Struggles Finally Start Coming To An End For 3 Zodiac Signs On June 10, 2025 - YourTango
(There is no concept of polarity, in the loop because the current changes direction 100 to 120 times a second (power frequency).
2024–10–10[John johnson John Johnson ]
This is where this question deviates from being a 'generic' question, and becomes more specific.
The bolt then partially travels down the line to your home.
The other is “what does a “fuse” do?”
2024–10–11 [Bobby Sanchez Bobby Sanchez ].
The U.S. Economy Is Headed Toward an Uncomfortable Summer - MSN
I post the exact comment here.
“ A surge suppressor is the one which is connected at the input supply so that when there is a sudden change voltage it bypasses thereby protecting the (circuit) and electronic components”
And this is the problem alone. Is the power supply in the equipmemt designed with a lightning strike in mind? Some yes, others, no.
“ A fuse is a device which protects the (circuit) against overload and short circuit.”
So, the voltage could go up to 500 volts, and the fuse will not open up.
When the current is 200% of the rated value , it will “go open” (the link metal melts) and protect the device.
What happens when you have paranoid schizophrenia?
Lightning arrestor is a spark-gap device, and can be installed anywhere. What is important, is that the wire is thick enough to withstand the lightning bolt and conduct the energy away from the building.
OK, this is Mohan Rajaratnam’s definition of a Surge suppressor.
a photo is worth a thousand words.
Ask Ethan: What are the "first stars" in the Universe? - Big Think
(Dc diagram shown, AC is similar).
This is an electronic circuit designed to clamp voltages so that the Voltage Potential that appears at the outlet is never going to exceed the nominal value.
but this device (an Inductor) … impedes the rapid changes in the current.
Thomson Reuters Ushers in the Next Era of AI with Launch of Agentic Intelligence - Thomson Reuters
For this case there are devices called Metal oxide varistors (MOV).
the problem then depends on "how fast does the fuse operate?".
This one hit behind the barn.
Dark matter 'lampshades' dimming stars could solve one of the greatest scientific mysteries - Space
So combined with a device called a MOV or Metal-oxide-resistor, then forms the 3rd part of a “surge suppressor “.
2024–10–11 [Victor Olarewsju Victor Olarewaju ]
2024–10–00 [ Ammar Mahdi ] Ammar Mahdi
Tender Moment Nurse Mare Adopts Orphaned Foal As Her Own Has Us in Tears - Yahoo
Barnstars:
[old diagram got deleted by accident]
It also is a device that limits the change in current flow.
Now when you have a certain ac resistance, then a current flows in a loop.
This device then solves the entire problem.
One is “what exactly is in a ‘surge protector’ ? ”
A circuit breaker is similar, but is resettable.
what exactly is a ‘surge’ protector?
If the nominal power is 4,000 watts then the current at 230volts is 16 amps.
A fuse is a non-resetable over current circuit protector.
At one ohm, the resistor has a maximum of 1 watt power.
Once the voltage goes over 0.0650 volts, then this fact can be used to amplify the difference, and turn the circuit breaker off , furthur down the line. Essentially that is what a RCD/GFCI does, it compares the incoming current, to the outgoing current, and if the difference between the two currents is over 5mA, then it trips the circuit breaker.
He then describes the function of a fuse.
What is lightning?
Because the load is inductive, the current lags the voltage.(by a bit).
P = e* I, so since I is 16 amps, then the voltage dropped is 1/16 volt or 0.0650 volts.
This is the picture of an electronic coil of wire wound around a core of magnetic material.
Fuses, on their own, then operate much slower than the MOV variable resistance, during the lightning strike.
These devices are installed between the “hot” and “neutral” and protective ground.
This is a photo where a lightning bolt took out a home's complete mains distribution box, and a lot of electronic gear as well.
This is where the MOV conducts again, and dissipated the energy.
so, what happens?
[image of Common-mode choke]
Mohan forgets that a fuse is a one-time device, and needs to be replaced if it is tripped.
It seems Mohan does not understand the difference between a comment and an Answer.
The MOV will conduct when the voltage exceeds 50% of line voltage.
So, it’s possible that these devices from Trip Lite have addition suppression devices, these ones seem to be sturdy.
2024–10–14 [Omar Gharbi Omar Gharbi ]
An AC voltage/ current source, and an ac inductive load.
It’s been three xxx five werks, and there has been no response to my follow on query on his Commment to my answer.
Can the fuse protect the electronic devices from lightning instead of a surge protector.
One
Here is a simplified AC power diagram.
This is 'the assistant's answer'
In schematic diagrams this is the symbol for a fuse:
These are simplified answers to the original question, and does not change anything I wrote above.
There are three different concepts here that are getting confused.
so, the loop of wire then, when put together with another loop reduces the ‘noise’ on a power line.
But during the surge, the fuse will not blow if it is a longer duration and lower value )10 to 50%).
but I think this circuit , shows a few more pieces.
“ … to protect building, lightning arrestor, is provided above building and directly connected to earth.”
What does a fuse do?
Would individual surge supressors have save this equipment? most likely, since the surge supressor would take the jolt instead of the electronic components.
2024–09–27 [ Mohan Rajaratnam Mohan Rajaratnam ] . Thinks you can get free electricity from nothing : Mohan Rajaratnam's answer to Is it possible to generate free electricity at home using a magnet or other low-cost methods? If so, how does it work?
He then describes Rainy Season and Lightning.
This is a high voltage low current spike that comes down the line because of the power poles being struck, and the voltage suppressors activating on the primary side of the transformer.
At the secondary, it is 1000 times less.)turns ratio). If it gets hit with a 100,000 volt bolt of lightning then the voltage arrestors conduct and clamp the voltage down to line voltage, ( but a small amount leaks down the line). This is the problem.
eight
2024–10–16 [ OO OLAOYE OYEBODE ]
nine
But… the neutral is now “floating” because of the 1 ohm resistance.
Is the question then , "why buy a surge supressor, if the fuse alone protects the electronic circuits from a lightning bolt?".